The next step is to do a full laser alignment. A new laser head has been mounted but it protrudes deeper into the bed area (this will limit the maximum height of the part), we are working on pulling the laser lens holder closer to the gantry. The new controller operating panel does not fit in the current opening so it is just loosely hanging on the front. This is to make their operation almost identical. A touch sensor like the Big Laser has also been installed. The Small Laser now has the same controller as the Big Laser. 1 Current Status - New controller installed and everything "works", just need laser alignmentĬurrent Status - New controller installed and everything "works", just need laser alignment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |